CADDX NX-6 Instalační manuál stáhnout pdf (Strana 11)

GE Security

Local programming lockout

This feature will disable programming of all locations, or for specified locations, from the

keypad (see location 21).

Log full report

A report can be sent to the central station when the event log is full (see location 37

segment 4).

Lost clock service light

The NX-6 can be programmed to light up the “Service” LED on a LED keypad or give a

“Service” message on a LCD keypad when the internal clock time is invalid due to power

loss. On LCD keypads, if programmed to show the system time, a “Set Clock, *97”

message will always be displayed (see location 37 segment 5).

Manual test

The NX-6 can be programmed to perform a bell and/or communicator test; to do this,

enter [*]-[4]-[4] while the system is in the disarmed state. Each time that [*]-[4]-[4] is

entered, a dynamic battery test will also be performed (see location 37 segment 2).

Night Mode

Applies to NX-1208E / NX-1248E keypads. In this mode, the control panel will bypass all

zones that have the Entry Guard feature enabled. (See location 23 and 111-169)

On board zone disable

The 6 zones on the NX-6 panel can be disabled, in order to obtain a completely wireless

alarm system. A mix of hardwired and wireless zones is also possible (see location 37

segment 5).

Partitions

The NX-6 can be partitioned into a maximum of 2 separate systems with distinct reporting

codes, user codes, and operating features for each system (see locations 26- 36 and

locations 171-205).

Program code

The factory default for the “Go To Program” code is [9]-[7]-[1]-[3] when using a 4-digit

code; or, if the 6-digit option is used, the default is [9]-[7]-[1]-[3]-[0]-[0]. The program code

can also be used as an arm/disarm code. If it is used as an arm/disarm code, and if

open/close reports are sent, the user code will be 255 (see location 43).

Quick arm feature

The NX-6 has a single-button “Quick Arm” feature which can be used to arm the system

by pressing the [Exit] key or the [Stay] key on the keypad. If closing reports are sent, the

user code will be 98 (see location 23 segment 1).

Recent closing

If this option is enabled, the NX-6 will send a “Recent Closing Report” to the central

station if an alarm occurs within 5 minutes after the panel is armed. The user number that

was used to arm the system will also be sent (see location 23 segment 3).

Re-exit

The NX-6 can restart the exit delay for a quick exit without the need to disarm the system;

this is done by pressing the [Exit] key while the system is still armed (= after exit delay

has expired). The re-exit is also logged (see location 23 segment 1).

Shutdown

This mode will cause the keypads to extinguish all LED’s, except the “Power” LED, and to

refuse keypresses (see location 21).

NX-6-EUR Installation manual Page 11 23/12/04

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 103 104

Komentáře k této Příručce

Žádné komentáře

CADDX NX-6 Instalační manuál Strana 11

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu CADDX NX-6