CADDX NX8EUA01 Uživatelský manuál Strana 6

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 18
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 5
6
Ready Light
The
ready light
is on when the system is ready to arm and flashes if ready to
force arm. The
ready light
is off when the system is not ready to arm because
of a zone(s) being faulted.
Stay Light
The
stay light
is on when the all interior (motion detector) zones are
bypassed.
Zone Light
The
zone lights
are off when everything is normal. A
zone light
will be on if
the zone has been bypassed. If a
zone light
is flashing, that zone is in alarm
or has been faulted. If a
zone light
is flashing rapidly, it means that the zone is
in a trouble condition. Trouble conditions are:
S
Tamper
S
Hardware
S
Low Battery
S
Loss of Supervision
(A combination of Alarm/Fault and Tamper/Trouble will produce a rapid
flashing light for a short period of time, followed by a slow flashing light.)
EMERGENCY ACTIVATION KEYS
NOTES: You must hold these keys for 2 seconds to activate these
functions. Your system may not be programmed for these activation keys
(see page 1)
. You should press these keys only in an emergency situation that
requires response by emergency personnel. If your system is programmed for
these functions, the following reports can be sent.
Fire Key This key can activate the fire alarm when pressed for two seconds. If
your system is connected to a monitoring center, an emergency report could be
sent to that center.
Auxiliary Emergency Key This key can activate the auxiliary alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be sent to that center.
Police (Panic/Hold-Up) Key - This key can sound a local audible alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be transmitted to that center. NOTE: Some Panic/Hold-
Up alarms are programmed to be silent at the protected site while reporting an
alarm to the monitoring center. Check with your installing company to determine
how your security system will respond to the Panic/Hold-Up activation.
Zobrazit stránku 5
1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Komentáře k této Příručce

Žádné komentáře