CADDX NX-6 Instalační manuál stáhnout pdf (Strana 35)

Chapter 2: Reporting codes

NX-6V2 Control Panel Installation Manual 31

Location 25 - Zones 1 to 8 zone type

Location 25 has eight segments of numerical data. Use this location to program

the zone type for zones 1 to 8. Use segment 1 for zone 1, segment 2 for zone 2,

etc. The segment defaults are 3, 5, 6, 6, 6, 6, 6, 6.

Location 26 - Zones 1 to 8 partition

Location 26 has eight segments of feature selection data. Use this location to

select the partitions (1 or 2) that zones 1 to 8 reside in. Each segment

corresponds to a zone (segment 1 to zone 1, segment 2 to zone 2, etc.). In each

segment, enter 1 for partition 1 or 2 for partition 2.

Location 27 - Zones 9 to 16 zone types

Location 27 has eight segments of numerical data. Use this location to program

the zone type for zones 9 to 16. Use segment 1 for zone 9, segment 2 for zone

10, etc. The segment defaults are 6, 6, 6, 6, 6, 6, 6, 6.

Location 28 - Zones 9 to 16 partition

Location 28 has eight segments of feature selection data. Use this location to

select the partitions (1 or 2) that zones 1 to 8 reside in. Each segment

corresponds to a zone (segment 1 to zone 1, segment 2 to zone 2, etc.). In each

segment, enter 1 for partition 1 or 2 for partition 8.

Locations 29 to 36 - Reserved

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 86 87

Žádné komentáře

CADDX NX-6 Instalační manuál Strana 35