CADDX 8600 Instalační manuál stáhnout pdf (Strana 6)

HOW TO PROGRAM THE 8600

The Ranger 8600 can be placed into the "Program" mode by either of the following methods.

1. Enter the 4 digit "Go To Program" access code (locations 28-31). At initial power-up the code

in these slots is [9]-[7]-[1]-[3]. The Ranger 8600 must be disarmed to gain access to

programming with this code.

2. Plug the optional model #8950 programmer into the 4-pin male outlet marked "program" on the

Ranger 8600 P.C. Board.

When the system keypad is utilized for programming (as described by method 1 above), the

Ranger 8600 will be in the "Program" mode, and the yellow LED's will display the data in location

000. The data is displayed using a Binary system. With this system the yellow zone 1 LED equals

"1" when illuminated. The zone 2 LED equals "2" when illuminated. The zone 3 LED equals "4"

when illuminated. The zone 4 LED equals "8" when illuminated. Thus if the data in location 000

is "9", the LED for zone 1 (=1) and zone 4 (=8) would be illuminated. By adding the two values

together, (1+8=9) you would determine that the data in location 000 is "9". If the data in location

000 is "6", the LED for zone 2 (=2) and zone 3 (=4) would be added (2+4=6) indicating the data

in that location to be "6". If no LED's are illuminated, the location contains a "0". To advance from

location 000 through 180, press the [#] key. To go to a specific location, press the location

number followed by the [#] key. The yellow LED's will then display the data in that location. Data

is changed by entering a number 0 to 15 followed by [r] (data enter key). Review the examples

in figure 1 on page 7.

When using the optional #8950 Programmer, the programming keystrokes will be the same as

with the system keypad. The #8950 however, has the ability to display the location number and

the data on the numeric display. See figure 2 on page 7.

There are three function codes that are used to program the Ranger 8600. These codes

are [2]-[1]-[0]-[#], [2]-[2]-[0]-[#], and [2]-[3]-[0]-[#], and are described below.

# After all the programming data has been entered into locations 000-180, you must enter the

code [2]-[2]-[0]-[#] to permanently load the information into the EEPROM. IF THIS STEP IS

NOT TAKEN, THE DATA IN THE EEPROM WILL NOT CHANGE, AND THE RANGER 8600

WILL NOT CHANGE CHARACTERISTICS.

# To change the data back to the original default values, enter the code [2]-[1]-[0]-[#] to load

the data into the RAM memory and then [2]-[2]-[0]-[#] to load that data into the EEPROM.

# To exit the Program mode after it has been accessed with the four digit "Go To Program"

access code, enter code [2]-[3]-[0]-[#].

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Žádné komentáře

CADDX 8600 Instalační manuál Strana 6